Xpelair VX150T 93227AW Kitchen/Bathroom Wall or Ceiling Extractor Fan with Timer - White (for use with 150mm / 6 Inch Ducting)

Really good little extractor you don't even know it's on silent running

Easy to install little difficult for cable entry, works well with good air flow

This was very simple to install and fit.It was a direct replacement for what I has before, that had seem better days.Wiring was easy, perfect size slot for cable and cable grip in right place. Note to ensure you use a magnetic screwdriver as trying to find a dropped screw in a small bathroom under the pan is quite difficult, especially with the electrics off and no light.Took me a while to find it with the help of a headtorch.I did apply a thin layer of silicone around the inner edges before screwing back up tight as this ensured a tight fit and stopped any resonance.It's been powered up non stop for several months now and still no noise and works great.If I get 12 months out of this with continuous running then I have no issues and will buy again.

Look: NeatMade: Plastic, not the best one, it is a bit flexi but I gues would last long.Installation: Pretty straight forward. There is a small notch on the side for the cable, but I think this is a bad idea, I never use them. Also, the fixing are only 2 screws so two corners which is not great due to flexibility of plastic leaving gaps on other two corners but noy a big deal.Performance: Air volume is what it says on listing, I can feel the air passes through the door. Excellent extraction.Noise: Pretty much the same as the extraction fan out there. I think this is normal.Value: I would say, I got more what I paid for. It is a good buy.

Purchased through Amazon from a company trading as “Energy Saving Bulbs/Products”It was a used. Somebody had clearly started fitting it then shoved it all back in the box complete with brick dust and dirt, the fittings bag open and the fittings loose in the box after a failed attempt to seal the bag with masking tape. I ended up getting a new one from cheaper Toolstation. That fan works well and not too noisy.

The plastic is quite flimsy and it's only mounted with screws in two of the four corners. This is a fan only supply not a complete extraction kit. You will need to buy ducting and damping grille separately.

I like the design, it seems it will be easy to clean. It is slightly bigger than the average(10cm) bathroom extractor fan so it is slightly louder as well. This is the 15cm model which is more than enough I need for the size of the room. Overall performance, price & design, I would say it is a good buy.

This fan does the job of extracting damp air well. Personally I wish I had bought the 4" fan as the drill for a 6" wall cutter are not so readily available as a 4". Having to hire a 6" cutter put the fitting price up. The fan itself though is good and comes with a timer